20.
Secure U-support tube (#21) to Strut Tubes (#17) with two Screws (#5)
as shown in
Figure 13
. Align holes in U-support with holes in Strut
Tubes and thread screw (#5) into hole in Strut Tube (#17). Tighten
screws all the way but be careful not to over tighten as you could strip
threads on screws.
21.
Attach Linkages (#16) to Leg (#19) as shown in
Figure 13
. Pivot Leg
(#19) out from the table top and pivot both linkages (#16) up and align
hole in Linkage with hole in Leg (#19). Attach Linkage (#16) to Leg
(#19) using Hex Head Bolt (#29), Spacer (#37) and Locknut (#34).
Spacer (#37) goes between Linkage and Leg. Attach other Linkage to
other Leg the same way. Tighten nuts securely.
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD
BE KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY
DAMAGE.
16
34
37
29
29
37
34
17
5
5
19
24
16
21
Spacer (#37) goes
between Linkage (#16)
and Leg (#19 & #24)
13
Figure
Note
: Make sure
to install #5
screws
Note
: Make sure
to install #5
screws
34
29
HARDWARE NEEDED
1/4-20 Locknut
(Qty. 2)
37
5
1/4-20 X 2 3/4 Hex Head Bolt
(Qty. 2)
3/8" Long Spacer
(Qty. 2)
#8 X 9/16
Screw
(Qty. 2)
16
