37
to create the ‘living zone’ and the ‘bedroom zone’, with temperature
regulation in each room according to different time schedules
programmed on two different chronostats. See the receiver’s
documentation for instruction how to associate outputs.
In the receiver, associated channels will receive from the chronostat
the time slot information and therefore the information of which
setpoint temperature, comfort or economy, to use for the regulation.
Also the off or antifreeze states are received by the associated
thermostats.
If the chronostat is regulating a comfort temperature, the associated
thermostats will regulate according to their setpoint knob
temperature, instead if the chronostat is regulating an economy
temperature, the associated thermostats will regulate according to a
reduction temperature which can be adjusted in the receiver.
Likewise if the chronostat is off with 5°C antifreeze function,
also the associated thermostats will regulate a 5°C antifreeze
temperature.
CLEANING PROGRAM
This program is particularly useful during cleaning when windows are
open and it is pointless either to heat or air condition rooms.
In such cases the output will remain Off for a two hours period.
To activate the program press the ‘ ‘ button: on the display the ‘
‘
icon will light up and in place of the clock, the time remaining until the
resumption of normal operation will be displayed.
The device will go back to the previous operating mode after two
hours or if you press the ‘
‘ button again.
VACATION PROGRAM
If you intend to be away for a relatively long period it is advisable
to activate the Vacation Program, which will suspend the active
operating mode for the desired number of hours (from 1 to 95) or
days (from 1 to 99).
At the end of the set number of hours or days, the chronostat will
go back into the operating mode it was in prior to activation of the
Vacation Program.
While it is off, the Antifreeze function will still be active and the ‘
‘ symbol will be shown on the display, along with the countdown of
the time remaining until the end of the program.
Note: Access to the vacation program will NOT be enabled while the
‘ cleaning program ‘ is on.
To activate the vacation program proceed as follows:
1.
Press the ‘ ‘ button: the display will show the ‘
‘ symbol and
the time ‘ h 00 ‘.
2.
Press buttons ‘ ’ and ‘
‘ to set the vacation time;
every
change will be automatically memorized
.
Up to 95 hours, the programming is indicated in hours and the
display will show ‘ h XX ‘.
Once that value is exceeded, the device will automatically switch
to the mode for programming the vacation time in days and display
will show ‘ d XX ‘. It will be possible to increase or decrease the
hour or day by one unit at a time, with values ranging from 0 .. 95
hours and 4 .. 99 days.
3.
To activate the vacation program for the set time, press the
- ENGLISH -
