32
QUICK GUIDE FOR SETTING THE TIME SCHEDULE
•
Press button ‘
P
’.
• The display shows ‘
PrOG
’ with the icon ‘
P
‘ turned on.
•
Press button ‘
OK
’.
• The display shows ‘ dAY ‘
•
Press buttons ‘ ‘ and ‘
‘ in order to choose one of the four
days combinations available as pre-set.
•
Press button ‘
OK
’ to confirm the choice.
• The display shows hour 00:00 with the relevant dash, in the
upside right, flashing.
• Press one of the following buttons to select the temperature
regulation level desired:
Comfort mode
:
Press the ‘
‘ button.
Economy mode
:
Press the ‘
‘ button.
Off / Antifreeze
:
Press the ‘
‘ button.
Moving the time cursor
: Press button ‘ ’ or ‘ ‘.
Each time the button which sets the regulation mode is depressed,
the time cursor automatically jumps into the next half hour.
• Once the time schedule for the day or group of days selected has
been set, press button ‘
OK
’.
The display will show the time schedule for the next day or group
of days until the whole week has been covered.
• Once the time schedule for the whole week has been set, press
button ‘
OK
’. The chronostat will store the program into its
memory and the word ‘
MEMO
’ is shown on the display, then it
will automatically quit the time schedule setting procedure.
- ENGLISH -
‘
tESt
’: TEST MODE ACTIVATION
Allows to activate/deactivate the ‘Test’ mode for the selflearning of
the radio address in the receiver:
On
‘Test’ mode active
OFF
‘Test’ mode deactive
See the ‘Radio system set-up’ section for further details.
‘
AFr
’: ANTIFREEZE SETTING
The Antifreeze function allows you to select a minimum temperature
to be maintained when the chronostat is off, so as to protect both
the room and the equipment when the room temperature falls below
the set value.
The device leaves the factory with the Antifreeze function set on
3°C.
IMPORTANT: the function is active only when the device has
been set in the heating mode.
To set the Antifreeze temperature, carry out the following steps:
1.
Select the parameter ‘
AFr
’ and press the ‘
OK
’ button.
2.
The display will show the previously set Antifreeze temperature.
3.
Press buttons ‘ ‘ and ‘ ‘
to change the setting (between OFF,
0.5°C..25°C); every change will be automatically memorized.
4.
To exit press the ‘
OK
’ button or else wait 10 seconds without
pressing any button.
‘MOrE’:
ADVANCED PARAMETERS MENU SETTINGS
The advanced parameters menu allows the installer to configure the
chonostat’s working.
