ESAB 1-1601-60, Руководство по эксплуатации

Страница: 22 / 50

CutSkill 60
OPERATING MANUAL
INTRODUCTION 2-10 0-5574
8. Over Temperature Error
This cutting power source is protected by a temperature sensor. The Over Temperature Error screen will be
displayed if the machine has over heated which normally occurs if the duty cycle of the power source has
been exceeded. Should the Over Temperature Error screen displays the output of the power source will be
disabled. Leave the power source turned On to allow the internal components to cool down. Once the power
source cools down sufficiently the Over Temperature Error screen will automatically disappear. Note that the
On/Off switch should remain in the On position such that the fan continues to operate thus allowing the power
source to cool sufficiently. Do not switch the power source Off if an Over Temperature condition is present.
Figure 2-22: Over Temperature Error Screen