ESAB 1-1601-60, Руководство по эксплуатации

Страница: 27 / 50

CutSkill 60
OPERATING MANUAL
0-5574 3-3 INSTALLATION
3.04 Air Supply Connections
A. Connecting Air Supply to Unit
1. Remove the red protective cap on the inlet port.
2. Connect the Nitto Air Fitting Nipple, Male Plug - 1/4" to the inlet port, or use other barb to connect to the inlet
port.
NOTE
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions. Do Not use Teflon
tape as a thread sealer, as small particles of the tape may break off and block the small gas passages in the torch.
3. Connect the gas line to the connector with quick disconnector or clamp. Refer to Figure 3-2.
NOTE
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions. Do Not use Teflon
tape as a thread sealer, as small particles of the tape may break off and block the small gas passages in the torch.
A-13890
Hose Clamp
Gas Supply
Hose
Nitto Air Fitting Nipple,
Male Plug-1/4",P-20PM
Gas Supply
Hose with Quick
Disconnector
8mm Hose Barb
Figure 3-2: Gas Connection to Compressed Air Input
B. Using Industrial Compressed Air In Gas Cylinders
When using Industrial compressed air in gas cylinders as the gas supply:
1. Refer to the manufacturer’s specifications for installation and maintenance procedures for high pressure gas
regulators.
2. Examine the cylinder valves to be sure they are clean and free of oil, grease or any foreign material. Briefly
open each cylinder valve to blow out any dust which may be present.
3. The cylinder must be equipped with an adjustable high - pressure regulator capable of outlet pressures up to
600-800 kPa bar maximum and flows of at least 110 LPM.
4. Connect gas supply hose to the cylinder.
NOTE!
Pressure should be set at 600-800 kPa at the high pressure gas cylinder regulator.
Supply hose must be at least 6 mm I.D..
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions. Do Not use Teflon
tape as a thread sealer, as small particles of the tape may break off and block the small gas passages in the torch.