7
MOUNTING INSTRUCTIONS
After uncrating the attachment, use the following procedure to mount the attachment to the loader.
Coupler wedges or pins must extend through the holes in attachment. Levers must be
fully down and locked. Failure to secure wedges or pins can allow attachment to come off and cause
injury or death.
1. Use the step, safety treads, and grab handles to
get on and off the loader and attachment.
2.
Sitting in the operator’s seat, lower seat bar and
fasten the seat belt.
3. Drive the loader to the rear of the attachment. Put
the loader quick attach coupler into the attachment
mounting bracket.
4. Tilt the loader coupler backward a small amount
until it is fully engaged in the brush mower
mounting bracket.
5. If you have manual levers, stop the engine and
engage the park brake. If not, proceed to step 6.
6. Secure the coupler locking mechanism that
attaches the attachment to the loader.
7. Connect the hydraulic quick couplers from the
attachment to the loader.
IMPORTANT:
Wipe the ends of the hydraulic quick
couplers (both lead and loader) with a rag to remove
any possible contamination. Contamination can
cause hydraulic components to fail and is not
covered under warranty.
IMPORTANT:
Make sure the quick couplers are
fully engaged. If the quick couplers do not fully
engage, check to see that the couplers are the same
size and brand. Do not force the quick couplers
together.
IMPORTANT:
You must connect the small, third
hose which is the case drain hose, or you will
permanently damage the hydraulic motor.
NOTE:
See the loader’s operator’s manual for further
instructions.
NOTE:
Attachment is shipped with 16FJX (1-
5/16”
Female JIC swivel) fittings on the ends of the lead
hoses
and 8FJX (3/4” Female JIC swivel) on the case
drain hose.
