8
MOUNTING INSTRUCTIONS
PRESSURE PORT
8. Make sure the hoses are properly routed to fit
your specific loader. If the hoses are not routed
correctly, hoses may get pinched or rub on tires
or tracks. Be sure to check the hose routing
through the full range of intended motion of the
attachment before operating it.
More than one routing may be acceptable
depending on the loader. Pick the routing that
best suits your loader.
IMPORTANT:
Proper hose routing is the
responsibility of the owner and/or operator.
Pinched or stretched hoses are not covered
under warranty.
Mounting is now complete and you are ready to use
the attachment. Use reverse order of above
instructions to dismount the attachment from the
loader.
NOTE:
Make sure the pressurized hose is routed to
the “MI” (MOTOR IN) port of the motor valve block.
If it isn’t, the attachment will not operate properly.
The proper hose to pressurize has PRESSURE
printed on the outer cover and/or a red cable tie on
the end.
If you are operating the loader controls correctly and
the mulcher still does not work, try switching the
hydraulic couplers around on the mulcher lead
hoses. This will effectively reverse the flow to the
motor.
