Erreka ARES AE3324D, Руководство по установке

Страница: 33 / 64

In
stalacion_68
v0.0.fm
- 9/4/16
English
ARES electro-mechanical operator
29
INSTALLATION
1
TOOLS AND MATERIALS
Electrician's screwdriver
Spanners (in accordance with the attachment screws used)
Allen key 6mm
Marker pencil
Level
Tape measure
Electric drill and broaches

Use the electrical drill in line with the use
instructions.
Wall-side and gate-side support attachment screws
2
INITIAL CONDITIONS AND CHECKS
Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the operator (see the
technical characteristics of the operator).

If the gate to be automated has a passage gate,
use a safety device to prevent the operator
from operating with the passage gate open.

The gate must be easy to manipulate manually,
namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its travel.

Do not install the operator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.
Electrical power supply installation

The electrical connections shall be made in line
with the instructions in the control panel
manual.

The electrical cable section is indicated in: “Fig. 1
Elements of the complete installation” on page 27.