18
R290 User’s Guide
To Change Key Tone Volume
To increase or decrease the key tone volume from standby, press the up
or down key on the side of the phone when no calls are in progress. The
volume level will be indicated by the number of squares shown on the
display.
To Redial the Last Dialled Numbers
With the phone in the standby state and no number displayed, press
SOFT RIGHT,
to display the last dialled numbers, select number and
press
YES
to dial. Press
NO
to finish the call.
Using Auto-Redial
If auto-redial is enabled from the Call Set-Up, Auto-Redial Menu and
your attempt to make a call was unsuccessful because the receiver was
busy or unobtainable, the message ‘
Auto Redial
’ will be displayed and
the number will be automatically re-dialled unless the party is not
available for a long term reason. Re-dialling will continue until the
number has been connected or the maximum number of 9 retries has been
exceeded. When the auto-redial attempt is activated, the auto-redial
warning tone will be played, the backlight switched on, and the message
‘
Connecting
’ will be displayed with the dialled number. See
“Autoredial” on page 30 for details on enabling and disabling Auto-
Redial.
You can enter menu mode, store and recall numbers etc. as normal,
between auto-redial attempts, but re-dialling will not continue until you
return to standby. If a supplementary service request is made, including
call hold and call wait, auto-redialling will be terminated.
If you reject an incoming call by pressing
NO
, the auto-redial will not be
terminated. It will be terminated only if the call is connected or the
maximum number of retries is exceeded, whereby the number will be
blacklisted so that auto-redial attempts to it are prevented. The blacklist
is reset after power off/on or when the auto-redial function has been
turned off/on. The blacklist should be cleared after 24 hours. When there
are no digits on the screen, pressing
NO
will terminate auto-redial.
To dial the last 10 numbers dialled, received or missed
Every time you dial a number, it will be stored in the Last Number Dialled
(LND) store if it does not already exist in the store. Also, every time you
receive an incoming call, if it contains a Calling Line Identification
Presentation (CLIP) number, it will be stored in the Last Number
Received (LNR) store. Every time you receive a call with CLIP and do
not answer it the number is stored in the Last Number Missed (LNM)
store.
To access the active last number store, press the
SOFT RIGHT
key in
standby.
Use discrete presses of
SOFT RIGHT
in standby to scroll through the
currently active store. Each store holds up to ten numbers. If the selected
store is empty, the message ‘
Store Empty
’ will be displayed before
returning to standby.
When a number is being displayed, you can use it to initiate a call by
pressing
YES
.
Refer to “Last Number Stores” on page 23 for a detailed explanation of
the Dialled, Received and Missed stores.
Содержание R290SAT
Страница 11: ...3 R290 User s Guide The Phone ...
