SanaBike 500 easy
Article-Nr.: 2.520132b
Revision: 10/2018
Page 8 of 21
Product description
The ergometer SanaBike 500 easy is intended for remote operation together with a master device (PC, ECG
unit or similar). It may also be operated in manual mode, where the load can be defined in steps of
5 watts by the user.
The colour touchscreen in the console shows the current measurement results as well as the manual load
control.
Device components
1.
Handle bar
2.
Saddle
3.
Clamp for saddle height adjustment
4.
Main switch ergometer, mains connection,
potential equalisation and RS-232 interface
(accessible from the back)
5.
Base adjuster for height adjustment
6.
Pedal cranks with pedals and safety straps
7.
Running gear
8.
Clamp for handle bar adjustment
9.
180° rotatable console with touchscreen display and
rpm display
Accessories
Every device comes with:
•
Mains cable
•
•
User manual
•
Inspection report
Potential equalisation
A standard potential equalisation stud is located on the rear panel, next to the power connection unit. It is
marked with a green/yellow information sign. Using an earthing cable, the ergometer can be connected to
the potential equalisation of the examining room, which serves as a common earthing point for all other
mains-operated devices in the room to ensure that all devices have the same earthing potential.
Note:
In electricity grids that are built and safeguarded according to European regulations, the earth wire (green/yellow) inte-
grated in the mains cable is used for potential equalisation. No additional earth cable should be connected in this case.
1
9
2
8
3
5
7
6
4
