Erbe ICC 200, Руководство по обслуживанию

Страница: 133 / 266

2 ERROR LIST 133
/ 266
Art. No.: 801
16-201
0
9
/ 200
4
ERROR no. 34–48
Error
no. Designation and remedies
34
Multiple activation detected during AUTO BIPOLAR .
No simultaneous activation via several sources.
35
There is already a new activation signal during AUTO BIPOLAR with AUTO STOP or AUTO
START.
No simultaneous activation via several sources.
36
When pressing the BIPOLAR AUTO START key, there is already an AUTO START signal .
The contact monitor is activated.
see ERROR no. 26.
Otherwise equipment defect: Technical Service.
37
Error during activation.
At the point in time of activation, the power supply unit voltage has not yet dissipated. Power
supply discharge faulty. Equipment defect: Technical Service.
38
During AUTO START activation, the contact resistance is < 6 ohms.
Inspection of the forceps and supply cable for short circuit.
39 not assigned
40
Monitor ST generator time control. Output error: ST time control for FORCE and SPRAY.
Actual value > set value plus 20%: Technical Service necessary.
41
Like Error 40, but
Actual value < set value minus 20%: Technical Service necessary.
42
Like Error 41, but
Actual value > set value minus 40%: Technical Service necessary.
43
Monitor of ST generator time control.
Output error. No frequency feedback: Equipment defect: Technical Service.
44
Monitor of the ST generator output voltage.
Output error: Equipment defect: Technical Service.
45
HF generator error during self-check.
HF output voltage too low : Equipment defect: Technical Service.
46
Self-check.
Error within the permissible limits during comparison of the power supply unit voltage with the
HF output voltage. Equipment defect: Technical Service.
47
HF generator error during self-check.
Like Error 46, but error outside permissible limits.
Equipment defect: Technical Service.
48
Patient current.
No signal from the output current monitor.
Equipment defect: Technical Service.