Erbe ERBOTOM ICC 350 M, Инструкция по эксплуатации

Страница: 30 / 100

4-10
setting is also to be used for the following operations, it can be accepted into this program. To do
this, only the SAVE key 6.1 must be depressed uninterruptedly long enough until “Set“ is indicated
on display 3.6 for Auto Coag 1 and the signal heard continuously during storage changes into an
intermittent signal.
WARNING
The operator and/or user of the unit must ensure that programs are not changed and stored
uncontrollably. Program changes must always be documented and all users must be informed.
Program b = Bipolar
With Program “b“, bipolar instruments connected to the bipolar
output of the unit can be used for coagulation and cutting.
The parameters for bipolar cutting with a choice of coagulation
effect are set via the AUTO CUT function field. The parameters
for bipolar coagulation are set via the AUTO BIPOLAR function
field.
Settings
AUTO CUT The HF power output for bipolar cutting can be limited in 1 watt steps
from
100 watts to 1 watt .
EFFECT
can be set from 1 to 4.
AUTO COAG 1 This function field is not limited and all parameters can be set.
AUTO COAG 2 This function field is switched off.
AUTO BIPOLAR The HF power output for bipolar coagulation can be limited in 1 watt
steps from
120 watts to 1 watt .
With the changeover switch for the blue pedal of a dual-pedal
footswitch,
activation can be blocked using the blue footswitch pedal.
Activation of
AUTO STOP is possible.
AUTO START is blocked in this program.