Erbauer ERB596CSW, Оригинальное руководство пользователя

Страница: 19 / 24

2000W 235mm CIRCULAR SAW ERB596CSW
BASE PLATE ANGLE ADJUSTMENT (See Fig. 5)
Adjusting the angle of the base plate (14) enables
bevel cutting. The base plate (14) must always be
held irmly against the material being cut to reduce
saw vibration, blade jumping or blade breakage
(See Fig. 3-1).
Loosen the base plate bevel lock button (5) and
rotate the base plate (14) to set the bevel angle
using the base plate angle scale (4) provided.
Then clamp the base plate (14) position using
the lock (5). Finally, check the angle and ensure
the base plate is irmly clamped. The angle
markings on the base plate (14) are accurate for
most general purposes but it is recommended for
accurate work to set the angle with a protractor
and make a test cut on other material. Do not use
the depth of cut scale when making bevel cuts due
to possible inaccuracy.
PARALLEL GUIDE ADJUSTMENT (See Fig.6)
Used for making cuts parallel to a work piece
edge at a chosen distance. Slide the parallel guide
arm through both ixtures to achieve the required
cutting distance and tighten screw to lock into
position (See Fig. 5). It can be used from both
sides of the base plate (14). There is a cutting
guide notch on the front of the base plate (14) for
using with a parallel guide (9). For straight cuts,
use the 0° guide mark to align with your parallel
guide scale. For a 45° bevel cut, use the 45°
guide mark to align with your parallel guide scale.
Securely clamp the parallel guide (9). Always make
a trial cut to check the setting.
Fig. 5
Fig. 6
4
5
9
14