254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
15
254MM (10”) COMPOUND MITRE SAW
15
254MM (10”) COMPOUND MITRE SAW
2) Place the outer blade collar (6) against the
blade and on the arbour. Thread the arbour bolt (8)
into the arbour counterclockwise. (See fig. 11)
Important
Make sure the flats of the blade collars are
engaged with the flats on the arbour shaft.
3) Place the blade spanner on the arbour bolt.
4) Press the arbour lock (5), holding it in firmly
while turning the blade spanner ounterclockwise.
When it engages, continue to press the arbour
lock in, while tightening the arbour bolt securely.
(See fig. 10)
Note
: Do not press arbout lock (5) when blade is
moving.
5) Rotate the cover plate (3) back until the slot in
the cover plate engages with the cover plate screw
(2). While holding the lower blade guard, tighten
the screw with a Phillips screwdriver. (See fig. 9)
Note
: The lower blade guard must be raised
to the upright position to access the cover plate
screw.
6) Lower the blade guard (1) and verify that the
operation of the guard does not bind or stick.
(See fig. 9)
7) Be sure the arbour lock is released so the blade
turns freely.
Warning:
●
To avoid injury, never use the saw without the
cover plate secure in place. It keeps the arbour
bolt from falling out if it accidentally loosens, and
helps prevent the spinning blade from coming off
the saw.
●
Make sure the collars are clean and properly
arranged. Lower the blade into the table and check
for any contact with the metal base or the turn
table.
