254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
Note
: All the adjustments for the operation
of this machine have been completed at
the factory. Due to normal wear and use,
some occasional readjustments may be
necessary.
A. Check Laser Beam Alignment.
1) Mark a 90° straight line across a board to
serve as a “pattern line” to test laser alignment.
Lay the board on the mitre table.
2) Plug saw into outlet and turn on the laser
beam and line it up with the pattern line.
3) Lower saw blade to pattern line and if blade
is not flush with the pattern line, adjust as
follows in procedure (B).
B. Adjusting the Angle of the Laser Guide
1) Turn the laser element (2) in the desired
direction to adjust the laser angle.
Note:
Do
not adjust the laser more than 1/4 turn in
either direction as this may damage the laser.
There are two flat sides on the laser element
where you can position an adjustable spanner
for your adjustment.
C. Aligning The Laser Beam
1) Loosen only 1/2 turn at a time the four set
screws (1).
2) Adjust laser by turning the left side set
screws clockwise to shift the laser line to the
right. To shift the laser line to the left, turn the
right side set screws 1/2 turn at a time.
3) Once alignment of the laser is achieved,
tighten only 1/2 turn at a time the four set
screws (1).
Fig 24
Fig 23
2
1
1
Laser Switch
Left Side View
Right Side View
2
2
