254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
21
254MM (10”) COMPOUND MITRE SAW
21
254MM (10”) COMPOUND MITRE SAW
8. Aligning the laser beam
Warning:
For your own safety, never
connect the plug to power source outlet
until all the adjustment steps are complete and
you have read and understood the safety and
operational instructions.
The laser beam must always be correctly
aligned with the blade to ensure straight, even
cutting.
Your tool is equipped with the Laser guide
using Class II laser beam. The laser beam
will enable to preview the saw blade path on
the stock to be cut before starting the mitre
saw. This laser guide is powered by the
transformed alternating current supply directly
through the power lead.
The saw must be
connected to the power source and the
laser on/off switch must be turned on for
the laser line to show.
CAUTION
●
AVOID DIRECT EYE CONTACT
Laser radiated when laser guide is turned
on. Avoid direct eye contact.
●
Laser Warning Label: Max output <1mW
Wavelength: 630-670nm EN 60825-1/
A1:2002. Laser radiation do not stare into
beam Class 2 Laser Product Puissance.
●
CAUTION-Use of controls or
adjustments or performance of procedures
other than those specified herein may
result in hazardous radiation exposure.
●
CAUTION-The use of optical
instruments with this product will
increase eye hazard.
●
Do not attempt to repair or disassemble
the laser. If unqualified persons attempt to
repair this laser product, serious injury
may result. Any repair required on this
laser product should be performed by
authorised service centre personnel.
