254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
254MM (10”) COMPOUND MITRE SAW
ASSEMBLY INSTRUCTIONS
Warning:
To avoid injury, do not connect this
mitre saw to the power source until it is
completely assembled and adjusted and you have
read and understood this Operator’s Manual.
Estimated Assembly Time: 5 minutes
1. Installing the mitre handle
1) Thread the mitre handle (1) into the hole (2)
located at the front of the mitre table. (See Fig. 3)
2. Saw blade spanner
1) For convenient storage and prevention of loss,
there is a slot (1) in the rear of the cutting head
handle (2) for storing the blade spanner (3) when
not in use. (See Fig. 4).
3. Cutting head
Raising
1) Push down slightly on the cutting handle (1) and
the lock lever (5).
2) Pull out the stop latch knob (2).
3) Allow the cutting head (3) to raise to the up
position. (See Fig. 5).
To avoid injury and damage to the
saw, transport and store the mitre saw with the
cutting head locked in the down position. Never
use the stop latch to hold the cutting head in a
down position for cutting operations.
Locking
When transporting or storing the mitre saw, the
cutting head should always be locked in the down
position.
1) Push the lock lever (5) and push the cutting
head (3) down to its lowest position.
2) Push the stop latch (2) into the locking hole (4).
Important
To avoid damage, never carry the mitre saw by the
switch handle, the cutting arm or the mitre handle.
Fig 3
Fig 4
1
Fig 5
2
3
1
1
Warning:
2
3
2
4
5
