Erbauer ERB015SDS, Руководство пользователя

Страница: 10 / 20

Loosen
Tighten
OPERATION INSTRUCTIONS
Note:
Before using the tool, read the
instruction book carefully.
1. Adjusting the auxiliary handle (See Fig
1)
For your personal safety we recommend using
the auxiliary handle at all times.
To adjust the handle, loosen the bottom of the
handle anti-clockwise and rotate the handle
around the handle collar until the handle is in the
desired position. Tighten fully.
2. Fitting SDS tools (See Fig 2)
Clean the bit shank and apply grease before
installing the bit. Hold the rotary grip, pull back
the lock sleeve and insert the SDS tool into the bit
holder. Turn the bit and push it in until a resistance
is felt, the shaft drops completely into bit holder.
Once you are satisfied it has seated, release the
black lock sleeve. This should lock the SDS tool
into position.
After installing always make sure that the tool is
securely held in bit holder by trying to pull it out.
If the SDS tool is not located repeat the installation
operation again.
3. Remove SDS tool (See Fig 2)
To remove the tool, pull back the locking sleeve,
hold and pull the tool out.
4. Operating the on/off switch (See Fig 3)
Press the on/off switch for operation and release
it to stop.
5. Using the Variable Speed control (See Fig
4)
The operating speed can be altered by turning the
variable speed control. Turn towards the higher
number to increase speed and towards the lower
number to decrease speed.
Fig 2
Fig 1
Fig 3
Fig 4
PDH130B ERB015SDS-M-070611.indd 10 2007-6-13 15:46:25