Erbauer ERB015SDS, Руководство пользователя

Страница: 13 / 20

6Kg SDS HAMMER DRILL
11. Lubrication machine (See Fig 13)
The machine has a grease-packed lubrication
system. Regularly check if there is sufficient
grease in the box every 10 hours of usage. To
check and to add grease, firstly remove the box
cover with a screwdriver. If it is not enough,
supply more grease provided with your tool into
the box (about 20g). The grease specification is #3
lithium based.
Caution: Keep the container of grease
away from children.
12. Replace the carbon brush as follows:(See
Fig 14&15)
Disconnect the plug from the power supply.
Unscrew the carbon brush cap with screwdriver
(not provide).
Remove the carbon brush. Check the length of the
brush and replace if under 6mm. When brushes
need replacement always renew both brushes,
even if one is still more than 6mm long.
Completely screw down the carbon brush cap.
Check that the tool is working. Before use, allow
it run for a few minutes to enable the brushes to
settle.
WORKING HINTS FOR YOUR
TOOL
1. Reduce the pressure on the drill bit when it is
about to break through. This will prevent the drill
from jamming.
2. When drilling a large hole, first drill a pilot hole
using a smaller drill bit.
3. Always apply pressure to your drill bit in a
straight line, and if possible at right angles to the
workpiece.
4. Never change the operating mode whilst the
drill is running.
5. Do not apply excessive pressure to the tool
when chiseling. Expressive force does not speed
up the work.
6. Alway hold with two hands when drilling.
Fig 14
Fig 13
Fig 15
PDH130B ERB015SDS-M-070611.indd 13 2007-6-13 15:46:26