Erbauer ERB015SDS, Руководство пользователя

Страница: 14 / 20

MAINTENANCE
1. Always grease the shank end of bits before
insertion.
2. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.
6. If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared cord
available through the service organisation.
TROUBLESHOOTING
1. If your hammer does not start, check the plug
on the mains supply first.
2. If your hammer becomes too hot in use, set the
hammer switch to the drill mode and allow your
drill to operate at maximum speed without load
for 2 minutes.
3. If your hammer work efficiency is too low,
please add sufficient grease in the grease box.
4. If your hammer use in low efficiency, please
check whether the tool is blunt.
5. If a fault can not be rectified return the tool to
an authorised dealer for repair.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local Authority or retailer for recycling
advice.
PDH130B ERB015SDS-M-070611.indd 14 2007-6-13 15:46:26