Equalizer International SWi12/14TM, Инструкция оператора

Страница: 10 / 40

OPERATOR INSTRUCTION MANUAL
IM_SWi_REV07_A4_English
SWi12/14TM; SWi20/25TE; SWi20/25TI
FLANGE SPREADING WEDGES
10
4.3
SERVICING
Replace missing worn or damaged parts. Use only
genuine Equalizer parts from approved distributors or
service centres. Equalizer parts have been engineered and
PDQXIDFWXUHGWREH¿WIRUSXUSRVH
Grease all moving parts by following the Lubrication
Procedure prior to usage, storage or transportation.
Do not exceed 5.0N.m (3.68ft.lb) of torque when
tightening the Jaw retaining screws. The jaws have been
engineered to have a small degree of movement when
correctly tightened.
If topping up or replacing hydraulic oil as part of a service,
use only premium quality hydraulic oil of the grade 15cSt.
4.4
LUBRICATION PROCEDURE
Apply grease following cleaning and servicing, prior to
usage, storage or transportation. Never assemble and
leave a tool without following the greasing procedure as
degradation or damage may occur.
Use only high pressure molybdenum disulphide grease.
Remove the jaws as per the dissassembly instructions.
Apply grease liberally to the following areas:
‡ WKHODUJHÀDWVXUIDFHRQWKHXQGHUVLGHRIWKHMDZV
‡ WKHLQWHUQDOÀDWVXUIDFHVLQWKHVTXDUHFXWRXWLQWKH
jaws
4.5
STORAGE & TRANSPORTATION
Equalizer tools should be stored in a cool dry place. Tools
should always be cleaned, serviced and lubricated prior to
storage. Ensure that tools are stored in their designated
packing cases.
4.
TOOL MAINTENANCE
4.1
INSPECTION
A thorough inspection should be carried out prior to usage,
storage or transportation to ensure the completeness and
condition of the tool.
Inspection should include:
‡ visual inspection of the outer parts of the tool,
checking for obvious damage, degradation or missing
parts
‡ visual inspection of the wedge-tip (requiring tool
actuation or jaw removal). Damage to the wedge-tip
is indicative of tool over-load.
Cleaning and servicing should be undertaken as required
prior to the tool being used, stored or transported.
4.2
CLEANING
To lightly clean the tool, wipe gently with a damp cloth.
If more thorough cleaning is required (for example
following immersion in water) carry out the following
cleaning procedure:
‡ strip the tool down, observing the schematics in
section 10.
‡ clean the components using detergent, following the
manufacturer’s guidelines
‡ rinse the components to remove traces of detergent
‡ dry the components thoroughly
Inspect, service and lubricate the tool immediately after
the cleaning process.