Item
Parameter
Explanation
Auto
-
The default setting of
Auto
is recommended in most situations. If
Media
Size Check
is not
On
when
Auto
is set, the appropriate tension is not
applied because the media width cannot be detected.
We recommend setting Manual in the following situations, and then
changing the setting value.
❏
When the media creases while printing
Set a larger value than the recommended values depending on the
media width you loaded.
❏
When banding (horizontal banding, tint unevenness, or stripes)
appears at irregular intervals in printing results.
Set a smaller value than the recommended values depending on the
media width you loaded.
❏
When the
Media Size Check
is set to
Off
Set the
Feeding Tension
value depending on the media width you
loaded. For details, see:
U
“Feeding Tension (SC-F7200/SC-F7100 Series only)” on page 65
Manual
0 to 40
Take-up Tension
*1
Auto
-
The default setting of
Auto
is recommended in most situations. If
Media
Size Check
is not
On
when
Auto
is set, the appropriate tension is not
applied because the media width cannot be detected.
If media wrinkles when printing, or white banding (white or light lines)
appears in the print results, we recommend using
Manual
and setting the
value to lower than Lv3. Make the same settings if ink adheres to the back
of the take-up roll. If thick media cannot be wound correctly, we
recommend using
Manual
and setting the value to higher than Lv3.
Manual
1 to 6
Media Tension
*2
0 to 40
The manufacturer default set values will change as follows depending on
the
Tension Measurement
setting.
Periodically
/
Every Page
: Lv28
Off
:Lv39
We recommend setting
Media Tension
in the setting menu to comply
with the width of the loaded media. The value depends on the
Tension
Measurement
setting. See the following for more information.
U
“Media Tension (SC-F7000 Series only)” on page 66
Prevent Sticking
*3
On
Select whether to enable (
On
) or disable (
Off
) operations to prevent
media from sticking when the printer is turned on or when printing starts.
Since operations take longer when
On
is selected, we recommend setting
this to
Off
. Depending on the media type, it may easily adhere to the
platen. If operations are performed while the media is on the platen, the
media is not fed correctly and could cause a jam. If this occurs, set
On
.
Off
Feed Speed
Auto
*1
The default setting for the SC-F7200 and SC-F7100 Series is Auto. The
default setting for the SC-F7000 Series is Lv2. The manufacturer default set
value is recommended in most circumstances. Set
Lv1
if thin media is
creased or torn or sticks together or horizontal lines appear during
printing. Note that the speed does not change when a large number (of
passes) was selected.
Lv1
Lv2
Restore Settings
Yes
If
Yes
is selected, the setting content of selected media settings are
returned to the default settings.
No
SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Using the Control Panel Menu
112
Содержание SC-F7000 Series
Страница 1: ...User s Guide CMP0048 01 EN ...
