Chapter 4 Technical Description
S5U13515P00C100 Evaluation Board User Manual (Rev 1.1)
EPSON
25
Connector H2 is a 0.1” x 0.1”, 10-pin header (5x2). The following figure shows the location of the connector H2.
Figure 4-10: C33 Debugger Connector Location (H2)
For the pinout of connector H2, see Section Chapter 6, “Schematic Diagrams” on page 29.
4.12 JTAG Interface
The S2D13515 Display Controller has a JTAG interface. All the JTAG signals are available on connector H1. Note
that connector H1 is not populated on the S5U13515P00C100 evaluation board.
Connector H1 is a 0.1” x 0.1”, 12-pin header (6x2). The following figure shows the location of the connector H1.
Figure 4-11: JTAG Connector Location (H1)
For the pinout of connector H1, see Section Chapter 6, “Schematic Diagrams” on page 29.