Chapter 4 Technical Description
S5U13515P00C100 Evaluation Board User Manual (Rev 1.1)
EPSON
19
4.6 LCD Interface
The LCD interface uses the FP1IO[23:0] and FP2IO[27:0] pins. All signals on these pins are available on connectors
H5, H6, and H7.
Connectors H5, H6, and H7 are 0.1” x 0.1”, 40-pin headers (20 x 2). The following diagram shows the location of
these connectors.
Figure 4-4: FP1IO and FP2IO Connectors Location (H5, H6, H7)
For the pinout of connectors H5, H6, and H7, see Section Chapter 6, “Schematic Diagrams” on page 29.
4.6.1 FP1IO Interface
The FP1IO interface signals have multiplexed functions. All FP1IO interface signals, except FP1IO18 and FP1IO19,
are available on connector H6. FP1IO18 and FP1IO19 signals go through 0 ohm resistors and are available on
connector H7.
The FP1IO interface can be configured as a LCD interface, 18-bit RGB input stream interface, or 8-bit YUV camera
interface and keyboard interface. For S2D13515 FP1IO interface pin mapping, refer to the
S2D13515 Hardware
Functional Specification
, document number X83A-A-001-xx.
4.6.2 FP2IO Interface
All FP2IO interface signals are available on connectors H5 and H7. For S2D13515 FP2IO interface pin mapping,
refer to the
S2D13515 Hardware Functional Specification
, document number X83A-A-001-xx.
