Epson S1C63358, Техническое руководство

Страница: 103 / 152

S1C63358 TECHNICAL MANUAL
EPSON
93
CHAPTER 4: PERIPHERAL CIRCUITS AND OPERATION (Serial Interface)
4.12.2 Mask option
(1) Terminal specification
Since the input/output terminals of the serial interface is shared with the I/O ports (P10–P13), the
mask option that selects the output specification for the I/O port is also applied to the serial interface.
The output specification of the terminals SOUT, SCLK (during the master mode) and SRDY (during
the slave mode) that are used as output in the input/output port of the serial interface is respectively
selected by the mask options of P11, P12 and P13. Either complementary output or N-channel open
drain output can be selected as the output specification. However, when N-channel open drain output
is selected, do not apply a voltage exceeding the power supply voltage to the terminal.
Furthermore, the pull-up resistor for the SIN terminal and the SCLK terminal (during slave mode)
that are used as input terminals can be selected by the mask options of P10 and P12.
When "Gate dirct" is selected, take care that the floating status does not occur.
(2) Polarity of synchronous clock and ready signal
Polarity of the synchronous clock and the ready signal that is output in the slave mode can be selected
from either positive polarity (high active, SCLK & SRDY) or negative polarity (low active, SCLK &
SRDY).
When operating the serial interface in the slave mode, the synchronous clock is input from a external
device. Be aware that the terminal specification is pull-up only and a pull-down resistor cannot be
built in if positive polarity is selected.
In the following explanation, it is assumed that negative polarity (SCLK, SRDY) has been selected.
4.12.3 Master mode and slave mode of serial interface
The serial interface of the S1C63358 has two types of operation mode: master mode and slave mode.
The master mode uses an internal clock as the synchronous clock for the built-in shift register, and
outputs this internal clock from the SCLK (P12) terminal to control the external (slave side) serial device.
In the slave mode, the synchronous clock output from the external (master side) serial device is input
from the SCLK (P12) terminal and it is used as the synchronous clock for the built-in shift register.
The master mode and slave mode are selected by writing data to the SCS1 and SCS0 registers.
When the master mode is selected, a synchronous clock may be selected from among 3 types as shown in
Table 4.12.3.1.
Table 4.12.3.1 Synchronous clock selection
SCS1
1
1
0
0
SCS0
1
0
1
0
Mode
Master mode
Slave mode
Synchronous clock
OSC1
OSC1 /2
Programmable timer
External clock
When the programmable timer is selected, the signal that is generated by dividing the underflow signal
of the programmable timer (timer 1) in 1/2 is used as the synchronous clock. In this case, the program-
mable timer must be controlled before operating the serial interface. Refer to Section 4.11, "Programmable
Timer" for the control of the programmable timer.
At initial reset, the slave mode (external clock mode) is selected.
Moreover, the synchronous clock, along with the input/output of the 8-bit serial data, is controlled as
follows:
• In the master mode, after output of 8 clocks from the SCLK (P12) terminal, clock output is automati-
cally suspended and the SCLK (P12) terminal is fixed at high level.
• In the slave mode, after input of 8 clocks to the SCLK (P12) terminal, subsequent clock inputs are
masked.