Setup & Operation 2. Specifications
S5 Rev.5
27
2.5 How to Set the Model
The Manipulator model for your system has been set before the shipment from the factory.
It is normally not required to change the model when you receive your system.
CAUTION
■
When you need to change the setting of the Manipulator model, be sure to set the
Manipulator model properly. Improper setting of the Manipulator model may
result in abnormal or no operation of the Manipulator and/or cause safety
problems.
If an MT label is attached to the rear of a Manipulator, the Manipulator has custom
specifications. If the Manipulator has custom specifications, the methods for setting the
model may differ from those described below. Please contact us with the number on the
MT label.
The method for setting the Manipulator model depends on the software used.
Refer to the chapter
Robot Configuration
in the EPSON RC+ User’s Guide.
NOTE
Содержание ProSix S5 Series
