Chapter 2
Running the Setup Program
The first time you use your Equity IIe, you need to run the
Setup program on the Reference diskette to define the
computer’s configuration. This is a simple procedure you must
do at least once. (You may need to do it again later, if you
change the configuration.)
The Setup program lets you set (or change) the following for
your computer:
Memory configuration
Type of display adapter (video) card installed
Power-on password
Auto speed function
Math coprocessor setting
Real-time clock’s time and date
Hard disk drive configuration
Diskette drive type(s)
Serial and parallel port settings.
The configuration you define with the Setup program is stored
in the CMOS RAM, which is permanent because it is backed
up by a battery. Whenever you turn on the computer, it
searches the CMOS RAM for the correct installation
information. If the computer discovers a difference between the
information in the CMOS RAM and its actual configuration, it
prompts you to run the Setup program.
Running the Setup Program.
2-1
Содержание Equity IIe
