NOTICE:
The following assembly steps are only a general guide to assist in the assembly of your Miami Vice and is not
a complete or comprehensive manual of all aspects of assembly, maintenance and repair. We recommend you consult a certified
bicycle mechanic to assist in the assembly, repair and maintenance of your bicycle. For detailed instructions please view the
Miami Vice assembly video and Quick Release Installation video found at www.bluerev.ca.
Assembly Instructions
Step 1 : Install the handle bars. Remove the four screws from the stem, ensuring the linear markings on the handlebars are centred and
handlebars are adjusted to the comfortable position. Finally, tighten the screws with the assembly tool.
Step 2 : Install the headlight. Use a socket wrench to hold the nut and loosen the screw with a screwdriver and remove the screw. Install the
screw pass through headlight and the bracket and adjust the headlight properly for riding conditions.
Step 3 : Remove the plastic guard from the front fork being sure not use the brake levers until the wheel is installed.
Install the front wheel and make the axlego through the centre of the wheel.
Tighten the nut on each side with the wrench included.
Install the plastic cap on each side of the axle.
Remember to verify all items are tight and torqued properly after your first couple of rides.
Step 4 : Use a bike pump with a press gauge to Inflate tires to desired PSI. The recommended pressure for this mode is 20 PSI (1.379Bar). Do
not over inflate or under inflate tires.
·
6
·
