EP Equipment EPT20-15ET, Руководство по обслуживанию

Страница: 42 / 128

31
REV. 09/2016
CHASSIS SYSTEM
4
4.3 Lifting Mechanism
4.3.1 Fork Inspection
Lower the forks completely down:
-
Fully lower the forks and switch off the power
supply;
-
Single Wheel : 75 mm ~ 78 mm
The truck is equipped with batteries, the height
from fork surface at center of load wheel to the
ground (h1):
-
Double Wheels : 83 mm ~ 87 mm
-
Ultra-low Placement : 42 mm
Lift the forks completely:
-
Single Wheel : 190 mm ~ 193 mm
The truck is equipped with batteries, the height
from fork surface at center of load wheel to the
ground (h2):
-
Double Wheels : 198 mm ~ 202 mm
-
Ultra-low Placement : 117 mm
4.3.2 Connecting Rod Adjustment
-
Lift the vehicle carefully with lifting equipment
through the lifting holes at at front and back;
Make sure the lifting equipment is solid and
secure, and the load capacity should be greater
than the total weight of the vehicle.Lifting height
of not more than 400mm, to prevent the hazards
to the maintenance personnel working under
the vehicle for connecting rod adjustment.
WARNING
-
Loosen the retaining nut, adjust the relative
distance between long rod and connector;
-
Turn the connector for 180° according to the
arrow direction in the figure, the forks can
then be lowered for 3 mm, whereas can be
lifted for 3mm;
-
Adjust the fork surface distance to standard
value, tighten the retaining nut.
Retaining Nut
Long Rod
Connector