EP Equipment EPT20-15ET, Руководство по обслуживанию

Страница: 40 / 128

29
REV. 09/2016
CHASSIS SYSTEM
4
-
4.1 Load Wheel
Lift the vehicle carefully with lifting equipment
through the lifting holes at back;
4.1.1 Removal and Installation
Removal
Make sure the lifting equipment is solid and
secure, and the load capacity should be greater
than the total weight of the vehicle.
-
Place a wooden wedge under the chassis
near load wheel, make the load wheel off the
ground;
When replacing wheels, be sure that the truck
won't tilt.
Double Wheels (see Figure 10102)
-
-
-
Remove the coiled elastic cylindrical pin (2)
within the wheel bridge (1) with an ejector pin;
Turn the wheel bridge to vertical direction,
knock out the wheel pin shaft (3) from side,
and remove the load wheel and bearing
assembly;
Remove the bearing (5) of load wheel (4) with
hammer and jacking equipment.
Installation and Commissioning
-
-
Install according to the reverse order of rem-
oval;
Run the truck to see if the load wheel is fun-
ctioning properly. If there is blocking or noise,
please install again.
WARNING
WARNING
Single Wheel (see Figure 10103)
-
-
-
Remove the coiled elastic cylindrical pin (1)
within the wheel bracket with an ejector pin;
Knock out the wheel pin shaft (2) from side
and remove load wheel and bearing assem-
bly;
Remove the bearing (3) of load wheel (4) with
hammer and jacking equipment.