EP Equipment CPD30L1-B, Руководство по обслуживанию

Страница: 41 / 235

29
REV. 05/2020
CHASSIS SYSTEM
4
Quality of tyres directly affects the stability and
driving performance of the device.
If you need to replace the factory-fitted tyres,
please use original spare parts provided by the
equipment manufacturer to reach the original
design performance of the truck.
4.1 Steering Wheel
4.1.1 Removal and Installation
Removal
Make sure the lifting equipment is solid and
secure, and the load capacity should be greater
than the total weight of the vehicle.
When replacing wheels, be sure that the truck
won't tilt.
Installation and Commissioning
- Install according to the reverse order of rem-
ova.
WARNING
WARNING
CAUTION
- Switch off the truck power and place the jack
under the chassis near steering wheel, make
the wheel off the ground;
(see Fig3131-10002SM)
-
-
Unscrew the eight nuts (1) on the steering
wheel assembly (2);
Remove the steering wheel assembly (2) from
the steering bridge (3).
-
-
Turn the wheel to see if it is rotating smoothly,
and if there is blocking or not;
Run the truck to see if the steering wheel is
functioning properly. If there is blocking or
noise, please check if the wheel bearings are
functioning properly (See Section 9.1).
-
-
Screw the eight nuts as shown in Fig3131-
10003SM.
Tighten the nuts by order and mark with the
torque: 640~758 Nm.
CAUTION