20
GB
Application examples
The IRelax irradiation device radiates heat
which penetrates deep into the skin, dilating
blood vessels and activating the blood cir-
culation.
This heat is distributed throughout the body
via the blood circulation, thus triggering its
effects.
The device is mainly used in physiotherapy,
whereby the promotion of circulation or an
increase in skin temperature is intended.
Therapy may only be undertaken in consul-
tation with the doctor treating you.
Typical areas of application are:
• Promotion of circulation
• Preparation for physiotherapy massages
• Reduction of pain in the fi eld of ENT
• Alleviation of muscle pain
• Prevention of fl u-type infections
• Alleviation of lower back ailments and
lumbago
Minimum clearances
Observe the minimum clearances during ir-
radiation
• Irradiation device to the body at least 70
cm
• Irradiation device to the head at least 120
cm
• Irradiation device to objects at least 30 cm
The surface of the irradiation device be-
comes hot when used. Ensure that you
do
not come into contact with the device
when in operation.
Exposure period
The best results can be obtained with an
ir-
radiation of 15 - 20 minutes.
Do not exceed
a continuous irradiation
period of 20 minutes
.
The device can be used several times per
week. On average, it is used 2 - 3 times per
week.
Looking into the lamp for extended periods
of time may lead to eye damage.
When facing the lamp, wear suitable safety
glasses or close your eyes.
Allow the device to cool down for at least 10
minutes before it is used again.
Initialisation
Ensure that the On / Off switch on the lamp
is switched off. The switch must be in switch
position 0.
Now connect the irradiation device using a
Schuko plug to a VDE-approved, earthed
230 V AC 50 Hz socket, fused with an earth
leakage circuit breaker.
You can now operate the device by switch-
ing the On / Off switch to switch position I.
The irradiation device must not be covered
up with towels or anything else. Risk of fi
re!
Switching off the device
In order to switch off the irradiation device,
press the On / Off switch again and switch it
