background image

16

GB

Safety regulations

•  Never leave the device to run unattended.

•  Do not use the heating device with a pro-

gram selection switch, a timer or any other 
regulating  device  which  switches  the  de-
vice on automatically.

•  It  is  forbidden  to  use  the  device  outside 

and  in  wet  areas  (shower  rooms,  steam 
saunas etc).

•  The  irradiation  device  may  not  be  used 

in  rooms  in  which 

fl ammable  substances 

are used (e.g. solvents) or in areas where 
there is a danger of explosion.

•  Never touch live components.

•  Do  not  insert  foreign  objects  into  the  de-

vice  openings!  Risk  of  injury  (electric 
shock) and damage to the device.

•  Be  especially  careful  when  cleaning  the 

refl ector  -  you  must  pull  the  mains  plug 
beforehand! Do not remove the protective 
grille!

•  Do not use abrasive or corrosive cleaning 

agents!

•  Never dip the device into water! Danger of 

death!

•  Switch  off  the  device  and  allow  it  to  cool 

down in order to adjust the lamp direction, 
to clean the device or to dismantle the de-
vice.

•  The device must not be operated without a 

protective grille.

•  The  device  surface  becomes  hot  during 

use. Do not touch the device when in op-
eration.

Risk of burn injuries!

• 

There  is  a  risk  of  burn  injuries  if  the 
device  is  covered.  Do  not  lay  cloth-
ing, towels or similar over the device 

to dry out.

•  Defective  mains  connection  lines  may 

only  be  replaced  by  the  manufacturer, 
their  customer  service  or  specialist  per-
sonnel  in  order  to  avoid  risks.  Never  put 
the device into operation if the supply line 
is damaged.

•  The mains cable must not come into con-

tact with hot device components!

•  Never  pull  the  cable  out  of  the  socket. 

Never  move  the  device  by  pulling  on  the 
cable or use the cable to carry the device!

•  Do not wrap the cable around the device! 

Do  not  operate  the  device  with  the  cable 
coiled.

•  Do not clamp the cable or pull it over sharp 

edges.  Do  not  lay  it  over  hotplates  or  an 
open fl ame!

•  A relative air humidity of 70% and a room 

temperature of 15 - 28°C must not be over 
or underrun.

•  Do  not  look  into  the  operating  infra-red 

lamp  for  a  prolonged  period  of  time,  or 
from  a  short  distance!  This  could  cause 
damage to the eyes.

When facing the lamp, wear suitable safety 

glasses.

•  There is a risk of damage to skin and eyes 

if these regulations are not kept to.

CAUTION!  Should  you  suffer  from 
any skin conditions or should you note 
changes in skin conditions, it is essen-

tial that you consult your doctor! 

Heizgerät

 

durch

 

Bestrahlungsgerät 

ersetzen

Содержание IRelax













Отзывы: