EOS Herkules XL S120 - Installation and Operating Instructions
63
Maintenance
6.6 Troubleshooting
Error
Reason
Solution
It takes the heater a long time to heat
up the cabin.
Some tubular heating elements are
defective.
Replace the tubular heating element
or heating coil. See
There is not enough space between
the stones.
Reshuffle the stones. See
There is insufficient ventilation.
Install the air inlets. If these are insuffi-
cient, add a fan to the openings. See
3.1.2 Air inlets and outlets,
Heater cannot draw in sufficient fresh
air.
Heater openings are clogged with lint
and dust. See
The electrical connection is defective.
Check the installation fuses.
Have the control unit's outputs
checked by a technician.
The position of the temperature sen-
sor is not optimal.
Check the position of the temperature
sensor and adjust as needed. See
3.2 Installing the temperature sensor
in the cabin,
The heater is very hot but cannot dis-
tribute the heat throughout the cabin.
There is not enough space between
the stones.
Reshuffle the stones.
The safety temperature limiter was
triggered and the heater no longer
heats.
The safety temperature limiter was
triggered by heat accumulation.
Check the inlets, outlets, and the fan
and ensure that the heater has access
to a sufficient amount of air.
The position of the temperature sen-
sor with the safety temperature limiter
is not optimal.
Check the position of the temperature
sensor and adjust as needed. See
3.2 Installing the temperature sensor
in the cabin,
23.
Water with foam is boiling over from
the vaporiser.
There are additives, e.g. essence or
essential oils, in the container for the
water.
Clean the vaporiser. See