4
GB
Package contents
(subject to change)
Included with the control unit are:
1. An heater-sensor board with overheat
shutoff protection, KTY-sensors with
sensor housing , two 3x25 mm
fastening screws and a 1,7 m long
sensor cable, red and white.
2. A plastic bag with three 4 x 20 mm
fastening screws and three spacer
tubes.
3. A replacement overheat protection
module.
General safety precautions
l
This device has not been designed for
being used by persons (including
children) that are physically or mentally
handicapped or have sensory
disabilities. Moreover, it is not allowed
to use this device without sufficient
experience and/or knowledge, unless
these persons will be supervised by
persons responsible for their security
or in case they have been instructed how
to use this device.
l
Children are to be supervised in order
to make sure that they do not play with
this device.
l
Attention: It is forbidden to install
the control box in a closed switch
cabinet or behind a wooden panelling!
l
The electrical installation may be
done only by a qualified electrical
technician.
l
You must comply with the regulations of
your power supply company and
applicable VDE regulations (DIN VDE
0100).
l
WARNING: Never attempt repairs
or installations yourself, as this
could result in serious injury or death.
Only a qualified technician may remove
the housing cover.
l
Please note the dimensions in the
Assembly of the control unit
Wall mounting
Mount the control unit outside the sauna
cabin only. The most practical mounting
point would be the wall area onto which
the sauna heater is mounted on the inside,
except on the outside of the cabin. If
electrical conduits are present, mount the
control unit accordingly. To mount the
control unit, please follow these
instructions:
assembly instructions, especially when
installing the temperature sensor. The
temperature above the oven is critical for
the temperature setting. The
temperature can be held within operating
parameters and a minimal temperature
gradient inside the bench area of the
sauna cabin can be achieved only if unit
is assembled correctly.
l
The device may only be used as
intended as a control unit for sauna
heaters up to 9 kW. (Up to 36 kW when
combined with a power control unit)
l
Completely disconnect the control
unit from the electrical circuit, i.e. flip
all circuit breakers or the main circuit
breaker during each installation or repair.
l
Please note the safety and installation
information from the sauna heater
manufacturer.
