Routine Cleaning and Maintenance
EXHAUST PASSAGES
(Biannually)
1. Open the firebox door by lifting the handle.
2. Remove the burn pot assembly and clean all the parts.
Firebox Baffle
Firebox Liner
Firebox Lower
Ashpan
Burner System
Figure 10: M-55-FS Exhaust Passages.
3. Lubricate all screws with
penetrating oil.
4. Lift the baffle, remove
the firebox liner, and lift
out the firebox lower.
Vacuum the firebox and
firebox liner thoroughly.
5. Open the ash box door;
remove the ash box and
cleanout the cavity.
6. Re-install the ash box,
firebox lower, firebox
liner, burn pot, and burn
pot liner
7. Close the firebox and ash
pan doors and secure.
BLOWER MECHANISMS
(Annually)
Unplug the stove then open the right and left side panels to access the two blowers. Remove the two (2)
5
/
16
hex head screws from the upper & lower edge located on the front edge of the panel. Vacuum all
dust from motors. The blower motors has sealed bearings, DO NOT lubricate this motor. Check gaskets
and replace if needed.
post season cLean-up
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
protection. It is very important that the stove be cleaned and serviced as stated above.
CLEANING PAINTED SURFACES
Please clean painted surfaces with a soft damp cloth.
FIREBOX LINER
The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in
no way covered by warranty.
DOOR GLASS REPLACEMENT
It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature
PYRO CERAMIC. To replace the glass, unscrew and remove the six (6) retainer nuts using a
5
/
16
” socket.
Remove the glass and any broken pieces. High temperature fiberglass tape should be used around the
glass in the same location as the original fiberglass. Insert the glass into the retainer, screw the door to
the retainer, and gently tighten nuts. The use of substitute materials is prohibited: #50-2025 Glass 14⅞”
x 11⅜” (378mm x 289mm).
14
