envea STACK 602, Руководство пользователя

Страница: 39 / 68

STACK 602 9 Maintenance
ENVEA UK Ltd
(PC-000848-MA Issue 5, December 2021)
vii
7.
Initial Setup
7.1 Introduction
This section provides information on the initial setup and operation of the control
units. The same procedure applies to both the Standard Controller (for Standard
Systems) and ProController (for PRO Systems).
For advanced configuration procedures, refer to the relevant control unit manual
(see the
Related Documentation
on page
11
).
7.2 Power-up Checks
Switch on the external power supply to the control unit. Check that the power LED
is ON, and the graphical display is illuminated.
When using the control unit for the first time, communication must be established
between the control unit and all connected devices in the network. If the control
unit is being reconfigured, then all existing settings can be cleared by performing
a Master Reset (refer to section
7.2.2
below or details).
7.2.1 Checking the Comms Mode
The Comms mode is set by ENVEA prior to installation and should have been
checked during the system installation.
1. Open the main Setup menu screen.
2. Select Other Functions | Advanced Functions .
3. Select Sensor Comms Mode and note the settings, which should be as
outlined in the following table.
Setting Mode Baud Rate Parity
Standard ASCII 19200 Odd
Optional RTU 19200 None
The Comms mode is set by ENVEA prior to installation and should be checked
during the system installation. If problems are encountered communicating with
a sensor, check that the sensor communications setting is the same as the control
unit Sensor Comms Mode setting (see section
0
on page
34
).
7.2.2 Performing a Master Reset
CAUTION! – LOSS OF DATA
Performing a Master Reset deletes all settings and logged data!
Download the data using the ENVEA software tool before carrying out a
system reset.
1. Open the main Setup menu screen.
2. Select Other Functions | Reset Functions .
3. Then select Master Reset to initiate the system reset.