Entrust Artista CR875, Инструкция по установке и руководство администратора

Страница: 94 / 150

84 Printer Manager
Transport
The
Transport
settings control card travel through the printer.Most settings are available for
WebService access-level users only. WebAdmin users can set values for ejecting a card from the
printer
Change settings as needed, and then click Set Current to apply the changes.

EjectTries —Specify the number of attempts (automatic retries) the printer makes to eject a
card though the output hopper. The first attempt to eject a card uses the speed specified in
the WebService
TransportSpeedMM setting. Subsequent attempts use the value specified in
FinalEjectSpeed .
A value of 0 specifies that the printer does not check if the card was ejected and does not
make additional attempts to eject the card.

FinalEjectSpeed —Select the speed at which to eject cards. Possible values are:

Normal: The speed used to eject a card is 125 motor steps/second. This is the default
value specified in TransportSpeedMM .

High: The speed used to eject a card is 138 motor steps/second.

TransMedSpeedMM —The speed at which the transport motor runs when clearing errors.
You cannot change this value.
VertTransport
The
VertTransport
setting controls the speed at which the vertical transport motor runs when
clearing errors.

VertTransMedSpeed —The speed at which the vertical transport motor runs when clearing
errors. You cannot change this value.
Description Default Value
Current Value
(unit) Allowed Range
1) EjectTries 3 3 [1 – 4]
2) FinalEjectSpeed Normal Normal
3) TransMedSpeedMM 67.733 67.733 [25.4 – 200.0]
Description Default Value
Current Value
(unit) Allowed Range
1) VertTransMedSpeed 67.733 67.733 [25.4 – 200.0]