Entrust Artista CR875, Инструкция по установке и руководство администратора

Страница: 18 / 150

8 Printer Installation
If you use Entrust Adaptive Issuance™ Remote Monitoring and Management Software to manage
your printers, you can disable the printer’s native configuration interface, Printer Manager, by
changing the
Behavior > WebServerSecure setting to Disabled . This prevents unauthorized
access to the printer and provides a higher level of security. Refer to “Behavior” on page 76 .
Install the Printer
The following sections describe the setup process when you first install the printer.
The printer ships with a standard 125-card input hopper. If you ordered the printer with an
optional multi-hopper, the printer is manufactured without an input hopper. This allows you to
install the multi-hopper with six input hoppers, each with a 125-card capacity.
An optional 125-card output hopper also is available and can be installed without tools on single-
hopper CR825 systems.
The following sections show the printer with a single hopper. Printer option-specific information
is noted, where necessary.

Unpack the Printer on page 9

Secure the Printer (Optional) on page 10

Install the Multi-Hopper on page 13

Plug In and Power On the Printer on page 16

Activate the Printer on page 17

Clean the Printer on page 19

Install Supplies on page 22

Install a Large Output Hopper on page 29
Caution: Do not disable the WebServerSecure setting unless you use Remote
Monitoring and Management software. You cannot re-enable Printer Manager to
manage the printer if you do not use Remote Monitoring and Management
software.