Entrematic LCU30H, Руководство по установке, Страница: 37 / 42

37
IP2251EN
Display Description Display Description
1-3 - Opening command S1. - Detection of stop during closure -
motor 1
1-4 - Closing command S.1. - Detection of stop during closure
- motor 2
1-5 - Step-by-step command 1-8 - Safety with closing reversal
P3 - Partial opening command. 1-9 - STOP command
3P - Opening command with operator
present 68 - Partial opening command
4P - Closing command with operator
present S2. - Detection of stop during opening
- motor 1
RX - Radio reception (of any memo-
rised key of a transmitter present in the
memory) S.2. - Detection of stop during opening
- motor 2
NX - Radio reception (of any non-mem-
orised key)
NB: with the selection → → , it
is also visualised when a command is received
from a non-stored transmitter.
OO. - Reaching of obstacle detection
limit during opening - motor 1
O.O. - Reaching of obstacle detection
limit during opening - motor 2
EX - Rolling-code radio reception out of
sequence OC. - Reaching of obstacle detection
limit during closing - motor 1
EP - Radio reception not complying with
the parameter configuration →
O.C. - Reaching of obstacle detection
limit during closing - motor 2
CX - Command received from AUX1 board RV - Enabling/disabling of built-in radio
receiver via RDX
FC. - Closure limit switch - motor 1 MQ - Learning operation of mechanical
end stops in progress
F.C. - Closure limit switch - motor 2 HT - Heating of the motors (NIO function)
in progress
FA. - Opening limit switch - motor 1 JR1 - Variation of the JR1 jumper status
F.A. - Opening limit switch - motor 2 1C - Closing operation (1 gate wing at
a time)