© Entrematic
Group AB 2015
20
6020031A — Commercial HVLS Fans
November 2016
OPERATING INSTRUCTIONS
Fig. 19
Fig. 20
Before operating the fan, read and follow the Safety Practices,
Warnings and Operating Instructions in this manual. Use by
untrained personnel could result in death or serious injury.
VERIFY PRIOR TO OPERATION
1. Power supplied to fan.
2. Obstruction clearance.
3. Safety cables (optional) properly installed.
4. All fasteners are properly torqued.
STARTING THE FAN
NOTE:
Pressing the
POWER ON
button once, while the fan is running
will set fan to full speed.
Visually inspect the fan to ensure that there are no obstructions
or personnel in the movement area.
1. Press the
FAVORITE
button. The fan will start and spin
up to approximately 2/3 full speed.
2. Adjust the speed by pressing either the
INCREASE SPEED
or
DECREASE SPEED
buttons. Each press of the buttons
will adjust the fan speed by approximately 5%.
STOPPING THE FAN
1. Press the
POWER OFF
button once to stop the fan.
PROGRAMMING THE FAVORITE BUTTON
NOTE:
The fan ships from the factory with the
FAVORITE
button
pre-programmed to approximately 2/3 full speed.
1. With the fan running, adjust the speed of the fan using
either the
INCREASE SPEED
or
DECREASE SPEED
button to achieve desired speed. See Fig. 19.
2. Once desired speed is achieved, press and hold the
FAVORITE
button for 10 seconds. This speed now
becomes the new
FAVORITE
speed.
CHANGING DIRECTION
1. The fan direction control is located on the top of the motor
assembly. To reverse direction, stop the fan and press the
button. See Fig. 20.
Fan direction control
and status light
Power on
Green LED
Increase speed
Favorite button
Decrease speed
Power off
