© Entrematic
Group AB 2015
November 2016
6020031A — Commercial HVLS Fans
15
Ensure
cable connectors
are firmly engaged.
Power cord
(to building power)
From fan
INSTALLATION,
continued
CONTROLLER INSTALLATION
Before doing any electrical work, make certain the power
is disconnected and properly tagged or locked off. All
electrical work must be done by a qualified technician
and meet all applicable codes. USE EXTREME CAUTION.
Touching wires could result in electrical shock, death or
serious injury.
On 120V fan, never allow more than 130 volts incoming
power to be connected to the controller box. Damage to
the fan and serious personal injury or death may result.
NOTE:
The controller box should be located outside of the blade arc
where possible and oriented such that the connections at
either end are accessible.
1. Install the controller box to building structure such that the
box is secure against movement. Fasteners not included.
2. Route the power and communication cables from the fan
mounting location to the controller box. Ensure that the
cables are routed clear of the fan blades and supported
throughout their run.
3. Connect the power and communication cables from the
fan to the controller box. See Fig. 12.
Ensure proper connection of the power and communication
cables. Do not alter factory supplied cables. Failure to
properly connect the cables can lead to operating issues.
4. Connect controller box power cord to building power. See
Fig. 13.
NOTE:
If fire alarm option is not being used, ensure fire alarm jumper
is in place to ensure proper operation. See page 24.
Building power
Power cord
(from controller box)
Line
Neutral
Ground
Fire alarm jumper
Fig. 12
Fig. 13
Fig. 14
