Remote Power Injector Installation
2-4 Cabling and Wiring
Use the following procedure to install the remote power injector.
1.
If available, use a cable tester to check the cable wiring to the AP. Check continuity
and pairing.
2.
Select a mounting location:
— Close to the Ethernet wiring panel or Ethernet port.
— Within six feet of an AC power outlet (if remote power is used).
3.
Secure the remote power injector.
If necessary, use the two wall anchors
provided in your installation kit.
4.
Insert the Ethernet cable into the
NETWORK jack.
5.
Insert the AP cable into the
ROAMABOUT AP jack.
6.
Proceed to
Chapter 3
, Installing the Access Point.
CAUTION: Before you connect to the remote power injector, verify
that the wired network connector is inserted into the NETWORK jack,
and the AP connector is inserted into the ROAMABOUT AP jack.
PWR
Network
Mounting
Hole (2)
R2_04
RoamAbout
AP
