Enterasys Matrix N Standalone Series, Руководство по настройке, Страница: 1084 / 1372

Routing Protocol Configuration Command Set
Configuring OSPF
13-32 Matrix NSA Series Configuration Guide
•
Set a priority to help determine the
OSPF designated router for the
network. ip ospf priority ( Section 13.2.3.5 )
•
Adjust timers and message
intervals. timers spf ( Section 13.2.3.6 )
ip ospf retransmit-interval ( Section 13.2.3.7 )
ip ospf transmit-delay ( Section 13.2.3.8 )
ip ospf hello-interval ( Section 13.2.3.9 )
ip ospf dead-interval ( Section 13.2.3.10 )
•
Configure OSPF authentication. ip ospf authentication-key ( Section 13.2.3.11 )
ip ospf message digest key md5 ( Section 13.2.3.12 )
Configure OSPF Areas.
•
Configure an administrative
distance. distance ospf ( Section 13.2.3.13 )
•
Define the range of addresses to be
used by Area Boundary Routers
(ABRs). area range ( Section 13.2.3.14 )
•
Enable area authentication. area authentication ( Section 13.2.3.15 )
•
Define an area as a stub area. area stub ( Section 13.2.3.16 )
•
Set the cost value for the default
route that is sent into a stub area. area default cost ( Section 13.2.3.17 )
•
Define an area as an NSSA. area nssa ( Section 13.2.3.18 )
Create virtual links. area virtual-link ( Section 13.2.3.19 )
Enable passive OSPF mode on an
interface. passive-interface ( Section 13.2.3.20 )
Enable redistribution from non-OSPF
routes. redistribute ( Section 13.2.3.21 )
Table 13-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...