Enterasys Matrix DFE-Gold 4G4202-60, Руководство по установке оборудования

Страница: 17 / 78

xv
About This Guide
This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys Matrix™ DFE ‐ Gold 4G4202 ‐ 60 and 4G4282 ‐ 41 modules.
For information about the CLI (Command Line Interface) set of commands used to
configure and manage the DFE ‐ Gold modules, refer to the Enterasys Matrix DFE ‐ Gold
Series Configuration Guide .
Who Should Use This Guide
This guide is intended for a network administrator responsible for installing and setting
up the DFE modules.
Note: In this guide, the following terms are used:
• DFE refers to Distributed Forwarding Engine series of modules.
• DFE-Gold module or module refers to the 4G4202-60 and 4G4282-41. If the
information applies only to one of the modules, the module is referred to by its model
number (such as 4G4282-41).
• Network expansion module or NEM refers to an optional uplink card installed on the
main logic board and accessible through the option slot of the 4G4282-41.
Important Notice
Depending on the firmware version used in the DFE-Gold module, some features described in this
document may not be supported. Refer to the Release Notes shipped with the DFE-Gold module to
determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.