Enterasys Matrix DFE-Gold 4G4202-60, Руководство по установке оборудования

Страница: 33 / 78

Enterasys Matrix DFE-Gold Series Modules Hardware Installation Guide 3-5
Example 3 ( Figure 3-1 , C)
Shows the primary management module missing from slot 1. As long as the module
installed in slot 2 is designated as a redundant management module, the module in slot 1
can be removed without affecting system operation. However, if there is no module in
slot 1, and the system is powered down, it cannot be restarted without a module in slot 1.
Rule: You cannot power up the system completely without a module in slot 1.
Example 4 ( Figure 3-1 , D)
Shows a chassis populated with 4xxxxx and 7xxxxx modules. DO NOT install 4xxxxx and
7xxxxx modules in the same chassis. In a 4xxxxx system, the chassis must be dedicated to
DFE ‐ Gold modules only. The chassis will be rendered inoperable if any other type of
module (DFE ‐ Platinum or legacy modules, for example) are installed in the same chassis
with DFE ‐ Gold modules.
Rule: In a 4xxxxx system, the chassis must be populated with only 4xxxxx boards to
operate.
Installing Module into a Chassis
To install a DFE ‐ Gold module into a Matrix E7 or Matrix N7 chassis, proceed directly to
“Preparation” on page 3 ‐ 6 to start the installation process.
Caution: When installing a module into slot 1 of a non-operating chassis, it is strongly
recommended that the module have the desired version of firmware. Installation of a
replacement module into slot 1 of a non-operating chassis requires reconfiguration of the
system settings.
Precaución: Para instalar un módulo en la ranura 1 del chasis apagado, lo mejor es que
el módulo corresponda a la versión de firmware solicitada. Para instalar un módulo de
reemplazo en la ranura 1 del chasis apagado será necesario reconfigurar el sistema.
Caution: Failure to observe static safety precautions could cause damage to the
DFE module. Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad
para la manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto
cortante entra en contacto con la placa o con los componentes, éstos podrían dañarse.