Enovation Controls Murphy PowerView PV380-R2, Руководство по эксплуатации

Страница: 20 / 30

Section 78 00-02-0997 (web only)
2019-10-07 - 18 -
Display Setup
Follow these steps to change the Display Setup:
1.
Press to display the Menu.
2.
Press to System Settings. Press to enter.
3.
Utilize keys 1, 2 and 3 to input the password (3482) and key 5 to enter.
4.
Arrow to highlight Display Setup. Press to enter.
5.
Highlight Gauge Setup and press to enter.
6.
To establish the default settings for the unit, highlight Use Defaults and press . A
Restoring Default Gauge Setup message will appear for approximately 6 seconds.
7.
For an alternate gauge display other than the default, highlight Customize Gauges
and press
.
8.
The gauge screen will appear with a check mark beside the upper left selectable
gauge. Press display keys 1 or 2 to cycle through the available options for that
portion of the screen.
NOTE : The available parameter options are limited to parameters that are
currently available on the CAN bus.
9.
To move to the next portion of the screen to customize, press . The check mark
will move.
10.
Repeat steps 8 and 9 until all gauges have been customized. Press to return to
the Menu.
11.
Highlight Engine Speed Dial and press to alternate between 3000, 4000 and
6000 RPM.
12.
Highlight Hour Meter Type and press to alternate between Engine Hours and
Machine Hours.
NOTE : If the type is set to Engine Hours, the unit must be connected to an
ECU and be receiving data to reset the service reminder. If Engine Hours
data is not being received, the service reminder will not reset.
NOTE : The interval remaining time may be negative when the service
reminder is expired.
13.
Press to be returned to the Display Setup menu.
14.
Highlight Fault Conversion and press to alternate between J1939 V1, V2, V3 or
V4.
15.
Highlight Auto Ack Fault and press to alternate between Disabled or Enabled.
16.
Highlight Clear Fault Codes and press to enter. A message will appear stating
“Request Sent to Clear Fault Codes.”
17.
WARNING: this step will take effect immediately after pressing . Highlight
Factory Reset and press
. A message appears stating “Restoring Factory
Defaults. The display will power cycle in 2 seconds.” The unit will then begin a