12
ENFORCER Access Control Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc.
Programming Format and Default Programming Values:
In this manual, the format used for programming the keypad is as follows:
•
A 2-digit (
XX
) FUNCTION identifier to tell the keypad what is being programmed.
•
A varying number of digits (
X
) to represent the parameters of that FUNCTION.
•
The
#
key to confirm programming of the FUNCTION.
The following is a list of the different programming functions:
Function
Parameters
Default functions and values
Page #
01
Master code
Default 0000, code length from 4~8 digits
13
02
Super user code
No default, must be programmed
14~15
03
Common user code for output #1
No default, must be programmed
15~16
04
Common user code for output #2
No default, must be programmed
15~16
05
Common user code for output #3
No default, must be programmed
15~16
10
User codes/cards for output #1
No default, must be programmed
16~17
20
User codes/cards for output #2
No default, must be programmed
16~17
30
User codes/cards for output #3
No default, must be programmed
16~17
40
Visitor codes for output #1
No default, must be programmed
17~18
41
Duress codes for output #1
No default, must be programmed
19~20
42
Duress codes for output #2
No default, must be programmed
19~20
43
Duress codes for output #3
No default, must be programmed
19~20
51
Output mode for output #1
5-Second output, momentary
21
52
Output mode for output #2
5-Second output, momentary
21
53
Output mode for output #3
5-Second output, momentary
21
55
System real-time clock
No default, must be programmed
22
56
Output #1 auto-disable time
No default, must be programmed
22~23
60
Wrong-code system lock-up
Locks keypad after 10 false code/card tries
24
70
User code entry mode
Manual entry of “#” after each code
24-25
71
Keypad sounds
Programming and operation beeps enabled
25
72
Output relay activation sounds
1-Second beep when output is activated
25
73
Center LED standby flashing
Center LED flashes on standby
26
80
Door-forced-open warning
Warning disabled
26
81
Door-propped-open warning
Warning disabled
27
90
Egress delay/warning/alarm
Egress output happens immediately
28~29
91
Door open alarm and timing
Alarm output is disabled
27
NOTE
: The Direct Access to Programming (DAP) code 2828 (page 30) and the system restore
code 9999 (page 13) are fixed and cannot be changed, even via programming.
