LOW BATTERY WARNING
When a Remote Transceiver Pack’s Battery Pack reaches a low power level, a repetitive “beep” tone will sound
approx. every 20 seconds over the connected Headset. If this occurs the Battery Pack should be removed,
recharged and replaced with a fully charged Battery Pack. Each WRAPS
™
System is provided standard with (2)
Spare/Additional Rechargeable Battery Packs.
POST OPERATIONS
After operations, power off and remove the Battery Packs from the WRAPS
™
System’s
components so they may be recharged.
To power off the “
Transceiver Base Station
,” rotate the “
ON/OFF VOL.
” located on the
outer/front of the device to the right until “click” sound is produced and then remove the
“
Battery Pack
” from the device
.
NOTE:
When powered off the device’s “
POWER STATUS
”
LED will turn off.
To power off a “
Remote Transceiver Pack
,” press and hold down the device’s power on/off
button for approx. (5) seconds then release and then remove the “
Battery Pack
” from the
device.
NOTE:
The LED located on the “
Remote Transceiver Pack
” will turn off to indicate
that the device has been powered off.
Follow the instructions contained within the “
BATTERY CHARGING & MAINTENANCE
”
section of this manual to charge the “
Battery Packs
” that have been removed.
Pg. 8 of 11
Ops Ver. 03/18
