BATTERY CHARGING & MAINTENANCE
The WRAPS
™
System’s Transceiver Base Station and Remote Transceiver Packs are powered by rechargeable
lithium polymer Battery Packs. When fully charged Battery Packs are used, the System may be continuously
operated for approx. (6) hours.
To optimize WRAPS
™
System performance and run time, it is important for the Battery Packs to be fully charged
before and after use as follows:
1.
Locate the “
Battery Charge Station
” and “
Battery Charge Station A/C
Power Adapter
.”
2.
Insert the pin end of the “
Battery Charge Station A/C Power
Adapter
” into the power port located on the outer/top of the
“
Battery Charge Station
.”
3.
Insert the plug end of the “
Battery Charge Station A/C Power
Adapter
” into a 120v wall outlet power supply.
4.
Insert a “
Battery Pack
” into any available charging bay located on the
“
Battery Charge Station
” checking that battery and bay’s contacts
(+/‐) are properly aligned.
5.
Once inserted press the “
Battery Pack
” downwards to secure its
position within the charging bay.
NOTE:
When properly inserted, the
LED located above the corresponding bay will turn on to indicate the
“
Battery Pack
” status.
a.
A
red
LED indicates that the “
Battery Pack
” is charging.
NOTE:
A fully depleted “
Battery Pack
” may take approx. (3) hours to
fully charge.
b.
A
green
LED indicates that the “
Battery Pack
” is fully charged.
6.
Once fully charged, remove the “
Battery Pack
” from the bay by lifting
it upwards.
Battery Charge Station &
AC Power Adapter
Pg. 4 of 11
Ops Ver. 03/18
Battery Packs Inserted into
Battery Charge Station Bays
